0
1. Current is measured in
watts
volts
amperes
2. When these numbers are multiplied, (6 × 10^3) (5 × 10^5), the result is
3 x 10^8
30 x 10^9
3 x 10^9
3. Which capacitor-store higher amount of energy?
air capacitor
paper capacitor
mica capacitor
4. The attraction between the nucleus and valence electron of copper atom is
zero
weak
strong
5. Which of the following is a type of error associated with digital-to-analog converters (DACs)?
nonmonotonic error
incorrect output codes
nonmonotonic and offset error
6. A binary-weighted digital-to-analog converter has an input resistor of 100 k ohm. If the resistor is connected to a 5 V source, the current through the resistor is:
50 micro amps
5 milli amps
5 micro amps
7. The output will be a LOW for any case when one or more inputs are zero in a(n):
OR
NOT
AND
8. A single transistor can be used to build which of the following digital logic gates?
AND
OR
NOT
9. Select the equation below that represents the relationship between charge, capacitance, and voltage for a capacitor.
C=QV
Q=CV
V=IR
10. After which time constant can a capacitor be considered to be fully charged?
first
third
fifth
11. A computerized self-diagnostic for a ROM test uses:
the check-sum method
ROM listing
ROM comparison
12. Which of the following memories uses a MOSFET and a capacitor as its memory cell
SRAM
DRAM
ROM
13. A nonvolatile type of memory that can be programmed and erased in sectors, rather than one byte at a time is:
flash
EPROM
EEPROM
14. A nonvolatile type of memory that can be programmed and erased in sectors, rather than one byte at a time is:
144
512
4096
15. If the resistance in a circuit with constant voltage increases, the current will
increase
decrease
stay the same
16. A damaged resistor
might have burnt
changed in resistance value
both
17. When referring to instruction words, a mnemonic is:
short abbreviation for the operand address
a short abbreviation for the operation to be performed
shorthand for machine language
18. Which bus is bidirectional?
data bus
control bus
address bus
19. The software used to drive microprocessor-based systems is called:
firmware
assembly language programs
flow chart instructions
20. A microprocessor unit, a memory unit, and an input/output unit form a:
CPU
compiler
micro computer
Score =
Correct answers:

Post a Comment

 
Top